Rufkahrs Furniture Hardware
Chair Rocking Chair Parts
» Chair Braces
Hip Hugger Clips AS-2700
AS-2700.. Sold in sets of 4. Antiqued Steel, Reproduced from the original. Made to fit a 7/8" diameter hiphugger. Outside dimensions- 1" long x 11/16" wide x 1/2" high. Screw hole- 1/4" diameter. (Steel Screws Included.)
Brass Plated Wicker Chair Brace D-2775
D-2775... sOLD BY THE eACH. Brass Plated Wicker Chair Brace, 45 degree Angle attaches to leg and bottom of chair for added support. Overall brace is 5-1/2 inches by 11/16 inches. Leg Brace sold by each not pairs Picture shows detail of both sides. Buy 8 or more and save!! Check details for larger Images!!
Turned Chair Rung W1-6146
W1-6146.. Sold by the Each. Approx. Size- 3/4" diam. x 24" long 1/4" pitch. Turned Chair Rung...Creates the appearance of wicker wrapped chair rungs and cross bars.
Turned Chair Rung W1-6147
W1-6147.. Sold by the Each. Approx. Size- 7/8" diam. x 24" long 1/4" pitch. Turned Chair Rung...Creates the appearance of wicker wrapped chair rungs and cross bars.
Oak Hip Hugger W3-2701
W3-2701.. Sold by the Pair. Approx Size- 6 1/2"h x 5 1/4" deep x 7/8" diameter. (Dimensions when installed.) 11" long from tip to tip when measured along the outer curvature. All measurements are approximate. One end is sanded flat to fit the chair seat, the other end is carved out to fit the chair back. Screw holes are predrilled. Unfinished, sanded and ready to install. Ends pointed. One left hand and one right hand hiphugger required per chair.
Hardware Tree features a full line of
Coffee and Tea Jars
, Books and more!
Stainless Steel Trash Grommets
Wire Grommets Plastic
Lazy Susan / Swivel
Ikea Drawer Slide Replacements
Butler Tray Hinges & Flip Top Hinges
Hoosier Cabinet Hardware
Antique Trunk Hardware
Shopping Cart Software by EcommerceTemplates.com